Ani Code Tx Delay (Ptt-Dly) - Menu 42; Transmitting The Id Code (Ptt-Id) - Menu 43; Ring Time (Inrg) - Menu 44 - Midland CT 890 Instruction Manual

MENU. To return to the standby mode, press EXIT.
To send out the alert tone, press PTT and then keep pressed the side key
PF2.

ANI code tx delay (PTT-DLY) - MENU 42

This function allows you to set the delay in sending the ANI code once
the PTT is pressed (ANI delay).
You can set it between 100 and 3000ms (30 levels of 100ms each).
To set the delay press MENU + 42; "PTT-DLY" will appear on the display.
Press MENU to enter the function. Select the desired level with the ▼/▲
keys or by rotating the encoder.
Press MENU again for confirmation and EXIT to return to standby mode.
Transmitting the ID code (PTT-ID) – MENU 43
With this function you can decide when sending the ANI code in tx mode.
The possibilities are 3:
• BOT: the code is sent when you press the PTT
• EOT: the code is sent when the PTT is released
• BOTH: the code is sent when you press and release the PTT
In Standby mode press MENU + 43; the display will show "PTT-ID".
Press MENU to enter the function. Push the ▼/▲ keys or rotate the enco-
der to select the desired option and confirm with MENU.
To return to the standby mode, press EXIT.
Ring time (INRG) – MENU 44
With this MENU you can select the ring time that you hear when the radio
receives its ANI code.
To set the ring time MENU + 44; the display will show "RING".
Press MENU to enter the function. With the ▼/▲ keys or with the enco-
der selection the desired option:
• from 1 to 10 seconds
• OFF
Press MENU again for confirmation and EXIT to return to standby mode.
24 | Midland CT890 instruction guide