Sending The Id Code (Ani-Sw) - Menu 32; Setting The Id Ani Code (Ani-Edit) - Menu 33; Dtmf (Dtmf-St) - Menu 34 - Midland CT 890 Instruction Manual

Sending the ID code (ANI-SW) – MENU 32
With this function, you can send the identifier code of your radio.
In Standby mode press MENU + 32; the display will show "ANI-SW".
Press MENU to enter the function. Push the ▼/▲ keys or rotate the enco-
der to select ON/OFF and confirm with MENU. To return to the standby
mode, press EXIT.
Setting the ID ANI code (ani-edit) – MENU 33
The identifier code is composed of 10 digits (0-9); the first one cannot
be 0.
The ANI code must be composed of 3 digits to 6 max.
In Standby mode press MENU + 33; the display will show "ANI-EDIT".
Press MENU to enter the function. Edit the ANI code with the keypad and
confirm with MENU. To return to the standby mode, press EXIT.
DTMF (DTMF-ST) – MENU 34
With this MENU you can select the following options:
• DT-ST: if you press any key on the keypad during transmission, the
speaker will send out the corresponding DTMF tone.
• ANI-ST: when you press PTT, the speaker will send out the correspon-
ding ANI code.
• DT+ANI: when transmitting, the ANI code and the DTMF tones will be
activated by the speaker of the radio.
• OFF: DTMF disabled.
In Standby mode press MENU + 34; the display will show "DTMF-ST".
Press MENU to enter the function. Push the ▼/▲ keys or rotate the enco-
der to select ON/OFF and confirm with MENU.
To return to the standby mode, press EXIT.
Midland CT890 instruction guide | 21