Rpt-Spk - Menu 38; Ptt - Menu 39; Adding A Channel To Scan (Scan Add) - Menu 40; Alert Tone (Alert) - Menu 41 - Midland CT 890 Instruction Manual

X-TWRPT: the radio transmits and receives at the same time, exactly as
in a phone conversation; keep pressed the RPT key and the full duplex
mode is active.
With the programming software you can set the tx delay when you rele-
ase the PTT.

RPT-SPK - MENU 38

This function deactivates the speaker when the repeater function is ena-
bled.
In Standby mode press MENU + 38; the display will show "RPT-SPK".
Press MENU to enter the function. Push the ▼/▲ keys or rotate the enco-
der to select ON/OFF and confirm with MENU.
To return to the standby mode, press EXIT.

PTT - MENU 39

In this MENU you can disable the PTT when the repeater function is ac-
tive.
In Standby mode press MENU + 39; the display will show "RPT-PTT".
Press MENU to enter the function. Push the ▼/▲ keys or rotate the en-
coder to select ON/OFF and confirm with MENU. To return to the standby
mode, press EXIT.

Adding a channel to scan (SCAN ADD) - MENU 40

With this function you add a channel to the scan channel list.
To enable it, you must first set the radio to CH mode.
In Standby mode press MENU + 40; the display will show "SCAN-ADD".
Press MENU to enter the function. Push the ▼/▲ keys or rotate the en-
coder to select ON/OFF and confirm with MENU. To return to the standby
mode, press EXIT.

Alert tone (ALERT) - MENU 41

In this section you set the alert tone; you can choose amongst the fol-
lowing alert tones: 1750Hz, 2100Hz, 1000Hz and 1450Hz.
In Standby mode press MENU + 41; the display will show "ALERT".
Press MENU to enter the function. Push the ▼/▲ keys or rotate the en-
coder to select one of above mentioned frequencies and confirm with
Midland CT890 instruction guide | 23