Table of Contents
Advertisement
Room Cabinet and Control Installation
The depth of the room cabinet varies by the amount the
wallbox extends into the room. Check the unit tagging against
the room cabinet tagging to be sure they match. Installation of
the control box should be done at the same time as the room
cabinet.
1. Remove the cabinet from the carton and inspect it for
damage. If any is found, contact the carrier immediately.
The room cabinet is made up of six pieces: a cabinet, a
removable front panel, a discharge grille, two (2) end
plates, and a kickplate. Make sure all pieces are included
with the room cabinet (Figure 19). Remove the front panel
by lifting it slightly and pulling forward, then upwards and
out from the surrounding cabinet.
Figure 18: Release Concealed Latch
2. Place the cabinet around the installed wall box, heat
section and cool chassis and push the cabinet firmly
against the wall. The discharge grille seals should rest on
the discharge opening of the heat section.
3. Fasten the cabinet to the wall using appropriate fasteners.
The back flanges of the room cabinet have factory
furnished holes for securing the cabinet to the wall.
Figure 19: Unit Cabinet Assembly Details
4. Fasten the two (2) end plates to the room cabinet using
the wing nuts supplied. These end plates are adjustable
and should be positioned to set flat on the finished floor
(Figure 20).
Figure 20: Unit Cabinet Assembly Details
5. Locate the kick plate and clip it into the slots provided in
the end plates so that the flange is toward the floor.
6. Take the control box and escutcheon plate out of the
carton for attachment to the room cabinet.
7. There are two flanges beneath the control door that
support the control box
Remove the two screws in the control box that hold the
escutcheon plate in place. Remove the thermostat knob
and escutcheon plate.
Installation
(Figure 21 on page
14).
IM 1068-2 / Page 13 of 28
Advertisement
Table of Contents
