Number Key Operation - Midland CT 510 Instruction Manual

Hide thumbs Also See for CT 510:

Table of Contents

Keypad beep setting

Press F/ and 9 BEEP to enter the keypad beep setting. rotate the

POWER/DIAL knob to select amongst OFF / TONE /VOICE.

CTCSS / DCS setting

Press F/ and 0 SQT to set CTCSS sub-audio tones and DCS digital

codes. If you push again F/ you set the tones in reception and/or

transmission. To switch between CTCSS and DCS press repeatedly

the VFO key.

OFF → CTCSS → DCS N → DCS I → OFF.To select a CTCSS tone or a

DCS code rotate the POWER/DIAL knob; press ENT to confi m and

U/V to exit.

10. Scan

Press F/ and VFO to start scanning. To change the scanning direc-

tion rotate the POWER/DIAL knob.

The scan can be done in VFO, MR and CH modes.

11. Channel storage

Press F/ and U/V; rotate the POWER/DIAL knob to store the

desired channel. Press ENT to confi m.

12. Menu mode

Press F/ ENT to enter the menu mode. See chapter "Menu opera-

tions".

Number key operation

In VFO mode, you can select a frequency directly by editing the number

on the keypad. If this number is out of band, the display will show "ER-

ROR". In MR mode this number selects a stored channel.

Instruction Guide Midland CT510

Table of Contents