Midland CT 510 Instruction Manual page 24

16. RX power saving (RX_SAV)
You can set the RX power saving in different levels from 1-1 to 1:4. Select
OFF to deactivate it.
In RX_SAV mode rotate the POWER/DIAL knob to select your choice.
Confi m by pushing PTT or ENT and exit with U/V key.
17. Scan mode selection (SCAN_S)
The Scan function is very useful to monitor the channels before transmit-
ting. You can set three different scan modes.
In SCAN_S mode, rotate the POWER/DIAL knob to select the desired
scan type:
Time-operated scan (TO)
When the radio detects a signal it will stop scanning; the status will re-
main about 5 seconds but the radio will continue to scan even if the si-
gnal is still there.
Carrier-operated scan (CO)
The radio will stop scanning when detects a signal and remains on the
same frequency until the signal is missing.
Search Scan (SE)
When the radio detects a signal, it remains on that channel and stop
scanning.
Confi m your selection by pushing PTT or ENT and exit with the U/V key.
18. Scan velocity setting
You can adjust the scan velocity from 100 to 500mS with a step of 50 mS.
19. Auto power-off APO_SW)
To set the automatic power-off rotate the POWER/DIAL knob till the di-
splay shows "APO"; confi m by pushing PTT or ENT and exit with the U/V
key. The radio will automatically turn off if there's not operation after the
pre-set time.
OFF:
"APO" off.
You can set the automatic power-off time from 30 to 180 minutes with a
step of 30 minutes.
Instruction Guide Midland CT510