Descriptions And Functions - VocoPro UHF-5816 Owner's Manual

Descriptions and Functions

RECEIVER
1. Power – This toggles power to the receiver ON/OFF .
2. Antenna Posts – These are where the antennas are connected .
Note: Each antenna can go on either post.
CHANNEL MODULES
3. Power LED – These indicate power to each of the modules .
4. RF LED – These indicate microphone connection to each of the modules .
5. AF LED – These indicate audio reception from each of the microphones .
6. SQ (Squelch) – These toggle the threshold at which the module will receive audio . If the strength of the
signal being received is too low, it will not be heard .
• 0dB – This means the threshold is low; meaning the range for the microphone is as far as it can be .
• -10dB – This means the threshold is high; meaning the range for the microphone is as short as
it can be .
7. Channel Switch – These allow the frequency of the microphones to be changed . There are 16 channels
to choose from .
8. Vol – These adjust the output volume for each of the microphone channels .
9. Mixed Output – This jack outputs all 4 microphone signals through a single ¼" unbalanced output .
10. Channel XLR Outputs – These jacks output their respective channel audio through balanced XLR
outputs .
11. Power In – This is where the included power adapter is connected .
Front Panel
Rear Panel
MICROPHONE
1. Power Switch – This toggles power to the microphone OFF/ON .
• MUTE – The middle position of the OFF/ON switch is the Mute function .
2. Power LED – This indicates the status of the microphone .
• Green – Battery is full .
• Red – Battery is low and needs replacing .
3. Battery Compartment – This is where the two AA batteries are installed .
4. Channel Switch – This allows the frequency of the microphones to be
changed . There are 16 channels to choose from .
11
Module