Contents Notice ..................4 Precautions................. 4 Package Contents ..............5 Items Needed to Complete ............5 Introduction ................6 Features ..................6 Getting Started ................7 Ikonnik ET4 Radio Sysytem ............8 Radient Reaktor60-4T Overview ..........9 Adjusting and Tuning Your Vehicle .......... 17 General Care &...
Therefore this product is not intended for use or maintenance by children without direct adult supervision. Helion RC and your hobby dealer shall not be liable for any loss or damages, whether direct, indirect, special, incidental, or consequential, arising from the use, misuse, or abuse of this product or any product required to operate or maintain it.
• If you have little or no experience operating R/C models, we strongly recommend you seek the assistance of your local hobby dealer. • Do not expose the transmitter to water or excessive moisture. • Do not operate radio controlled products in a lightning or thunder storm. •...
Introduction Select by Helion was born from the quest for the ultimate marriage of performance, value and innovation. It’s not an easy task compromising so we have done our best not to. We’ve included what we believe to be the best radio system in its class;...
Getting Started Below are some steps to help get you going right away and most applicable to those who have used RC products before. If you are new to the hobby or it has been a while since you’ve worked with the latest technology, please read through the manual to acquaint yourself with the latest procedures, Warnings, Cautions and Tips.
Preparing to Drive 1. Remove the body from vehicle. 2. Loosen the hook-and-loop battery straps. 3. Install the fully charged battery into the vehicle, be sure to secure the battery straps to keep the battery in. Note/Tip: If you are you using a tall high capacity battery, optional long straps are available to suit your configuration.
Radient Reaktor60-4T Brushless System Overview The Radient Reaktor series brushless motor and ESC is a great power plant to satisfy your need for speed and performance, not just an entry level brushless system, your Reaktor system has some of the most advanced technology in ESC and motor development in the industry today.
Page 10
black wires, this is okay. On sensorless brushless systems the motor will change operating direction when any two of the motor wires are swapped. PLUG FOR POWER COOLING FAN CAPACITOR GOLD BULLET CONNECTORS INDICATOR MOTOR RECEIVER SETUP BUTTON TO BATTERY (THIS CONNECTOR IS ON/OFF COMPATIBLE WITH...
Page 11
• The green LED lights when the throttle trigger is moved to the full throttle position. Alert Tones: • Input voltage abnormal alert tone: The ESC begins to check the input voltage when power on, if it is out of the normal range, such an alert tone will be emitted: “beep-beep-, beep-beep-, beep-beep-”...
Page 12
Programming your ESC The Radient Reaktor is a programmable ESC. Although the default settings should work well for most users, these settings exist so that you can fine tune the performance of your ESC to your experience and components. Its various programmable parameters can be adjusted either by interfacing with the ESC directly (button presses and counting LED flashes), or via the optional Reaktor Program Box (RDNA0031) which includes a digital readout of the...
Page 13
CAUTION: SWITCHING FROM REVERSE TO FORWARD THROTTLE POSITION QUICKLY WILL CAUSE EXCESS LOAD ON THE ELECTRONICS AND DRIVETRAIN OF YOUR VEHICLE. IT IS RECOMMENDED TO COME TO A STOP BEFORE CHANGING REVERSE/FORWARD DIRECTION. Item 2: Drag Brake Force (Automatic Brake): 1.
Page 14
more than 2 seconds. Since the setting is “per cell” this means that if you are running a 2 cell battery, the voltage protection will activate relative to 2 x 2.6V = 5.2V. This setting is primarily for use with LiFe type batteries as the lower end of LVC settings.
Page 15
happens, reduce the maximum braking force to a lower setting. If however you are unable to stop and the lack of deceleration is not due to wheel slipping, you can increase the braking force. CAUTION: BE SURE TO CHECK YOUR MAXIMUM BRAKE SETTINGS BY DRIVING FROM FULL THROTTLE TO FULL HARD BRAKE IN AN OPEN AREA.
Page 16
Programming Table and Default Settings: Use the tabel below to better understand the programming process. This should help you navigate thorugh the programming menu. Programmable Value (Blinks of RED LED), Black background indicates default settings Programmable Items (Blinks of GREEN LED) Forward/ Forward Running Mode...
Adjusting and Tuning Your Vehicle The Select Four 10SC has been engineered with some available tuning options listed here for reference. The default configuration has been chosen to provide what we feel is the most enjoyable experience for most operating conditions.
changing position in the battery tray. • It may be necessary to reset the ride height after changing to a heavier/ lighter battery or making a setup change. General Care • Always use clean, dry cloth or soft bristle brush to clean your equipment. •...
Page 19
Receiver Although the receiver included with your radio system is rated for all weather use, it is recommended that you avoid submersion of the receiver, however running in puddles, rain, and snow is okay. CAUTION: ALTHOUGH THE ELECTRONICS ARE PROTECTED FROM THE WEATHER, THE CONNECTIONS ARE NOT.
Setting the Gear Mesh 1. Loosen the clamping screw securing the motor plate’s rotation in the motor mount, only enough to allow the motor to rotate in the mount. Check and ensure there is no debris in the gears affecting the mesh. 2.
Page 21
3. Slowly compress the shock shaft 100% of travel using a towel or paper napkin to clean up overflowed oil, then reinstall the bleed screw. Do not over-tighten. 4. Check for free motion of shock. If the shock feels like it gets stiffer at the end of compression, there is too much oil or air.
Storage and Disposal Storage • Always store all equipment in a cool dry place when not in use. • Always disconnect the batteries before storage. • Never store the transmitter or receiver in direct sunlight for extended periods of time. •...
Page 23
become tangled or wrapped around the spinning parts of the drivetrain. Small objects like fishing line for example, can wrap around a drive shaft, overheat and melt due to the friction and cause the entire drivetrain to lock up. Although a big problem, it can be difficult to see when inspecting. Always remove the wheels from your vehicle when troubleshooting drivetrain related issues.
Appendix A: Troubleshooting Guide for the Reaktor Power System Problem / Symptom Possible Cause Possible Solution Receiver and transmitter not bound Try re-pairing Unless using Futaba radio, set Th channel to Re- ESC will not set to Throttle Channel not set to Reverse verse transmitter Batteries dead in car or transmitter...
Appendix B: Troubleshooting Guide Problem / Symptom Possible Cause Possible Solution Battery voltage too low Charge battery Vehicle will not turn on Battery not connected Re/connect battery Damaged battery Replace battery Transmitter will not Battery voltage too low Charge or change batteries turn on Battery/ies installed improperly Correct installation...
Appendix J: Spare Parts List HLNS1001 Four 10SC, 4wd Brushless Short Course Truck HLNS1002 Bulkhead, Aluminum (2) (410SC) HLNS1003 Motor Mount (410SC) HLNS1004 Motor Mount Cam (410SC) HLNS1005 Steering Spindle, L-R (410SC) HLNS1006 Hinge Pin Set (410SC) HLNS1008 Ring Gear, 43T (410SC) HLNS1009 Pinion Gear, Bevel, 15T (410SC) HLNS1010...
Helion RC product. If you purchased your Helion RC product from a HobbyTown® internet site not affiliated with a local store, please consult that site for its service policies.
Page 40
Model Engines Warranty Information HELION RC 60 DAY WARRANTY Model Engines (Aust.) Pty. Ltd. warrants this product to be free from defects in materials or workmanship for 60 days from the date of purchase and will repair, replace or refund the purchase should the product prove to be defective.
the goods fail to be of acceptable quality and the failure does not amount to a major failure. Model Engines (Aust.) Pty. Ltd., Unit 1, 158-168 Browns Road, Noble Park, Victoria, 3174, Australia. www.modelengines.com.au Ph (03) 8793 5555 warranties@modelengines. com.au This warranty information relates to goods supplied on a wholesale basis by Model Engines (Aust.) Pty.
Page 42
Scan this QR code with your smartphone for more information 000567-001 (REV B) www. Helion-RC.com...