Sony HCD-VX99 Service Manual page 18

Table of Contents

Advertisement

QQ
3 7 63 1515 0
2. Turn the adjustment screw and check output peaks. If the peaks
do not match for L-CH and R-CH, turn the adjustment screw
so that outputs match within 1dB of peak.
within
L-CH
1dB
peak
Output
level
R-CH
peak
Screw
position
L-CH
peak
3. Mode: Playback
test tape
P-4-A100
(10 kHz, –10 dB)
pin 3
L-CH
pin 2
MAIN
L
board
CN301
R
set
R-CH
pin 1
waveform of oscilloscope
TE
L 13942296513
in phase 45 °
good
4. After the adjustments, apply suitable locking compound to the
pats adjusted.
Adjustment Location: Playback Head (Deck A).
Record/Playback/Erase Head (Deck B).
www
.
forward
reverse
18
http://www.xiaoyu163.com
within
1dB
Screw
position
R-CH
peak
oscilloscope
V
H
90 ° 135 ° 180 °
wrong
x
ao
y
i
http://www.xiaoyu163.com
8
Tape Speed Adjustment
Note: Start the Tape Speed adjustment as below after setting to the test
mode.
In the test mode, the tape speed is high during pressing the
CD SYNC HI-DUB
Procedure:
1. Turn the power switch on.
2. Press the x button, ENTER button and DISC 3 button
simultaneously.
(The "TEST MODE" on the fluorescent indicator tube display
while in the test mode.)
To exit from the test mode, press the ?/1 button.
Mode: Playback
test tape
WS-48B
(3 kHz, 0 dB)
set
1. Insert the WS-48B into the deck B.
2. Press the gG button on the deck B.
3. Press the CD SYNC HI-DUB button in playback mode.
Then at HIGH speed mode.
4. Adjust RV1001 on the LEAF SW board do that frequency
counter reads 6,000 ± 30 Hz.
5. Press the CD SYNC HI-DUB button.
Then back to NORMAL speed mode.
Q Q
3
6 7
1 3
6. Adjust RV1002 on the LEAF SW board so that frequency
counter reads 3,000 ± 15 Hz.
Adjustment Location: LEAF SW board
Playback level Adjustment
Procedure:
Mode: Playback
test tape
P-4-L300
(315 Hz, 0 dB)
Deck A is RV302 (L-CH) and RV352 (R-CH), Deck B is RV303
(L-CH) and RV353 (R-CH) so that adjustment within adjustment
level as follows.
Adjustment Level:
CN301 PB level: 301.5 to 338.3 mV (–8.2 to –7.2 dB) level
difference between the channels: within ±0.5 dB
Adjustment Location: MAIN board
Sample Volue of Wow and Flutter: 0.3% or less W. RMS
u163
.
2 9
9 4
2 8
DECK B
button.
frequency counter
+
main board
CN301 (Pin 3
: L-CH)
(Pin 1
: R-CH)
1 5
0 5
8
2 9
9 4
DECK A
DECK B
level meter
+
set
main board
CN301 (Pin 3 : L-CH)
(Pin 1 : R-CH)
(WS-48B)
m
co
9 9
2 8
9 9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents