Installation; Adding The Data Password; Firmware Version Information - Kenwood TK-7360 Service Manual

TK-7360/7360H/7360H

6-1. Adding the data password

If the read authorization password is set in the optional
feature menu, you must enter the password (Source trans-
ceiver) to activate a clone mode.
You can use 0~9 to confi gure the password. The maxi-
mum length of the password is 6 digits.
1. [ ]+Power ON.
2. "CLONE LOCK" is displayed on the LCD.
3. If the [ ] and [ ] keys is pressed while "CLONE LOCK"
is displayed, numbers (0 to 9) are displayed flashing.
When you press the [
number is determined. If you press the [ ] key after en-
tering the password in this procedure, "CLONE MODE"
is displayed if the entered password is correct. If the
password is incorrect, "CLONE LOCK" is redisplayed.
Cloning cable
(E30-3382-05)
1. Connection Cable (KCT-60: Option)
The KCT-60 connection cable kit is used to connect the
transceiver to a Horn alert cable, KCT-18 (Ignition sense
cable), KES-5 (External speaker), or through the KCT-36 ex-
tension cable.
1-1. Installing the KCT-60 (Connection cable) in the
transceiver
1. Remove the ACC. cap on the rear of the transceiver.
2. Connect the D-sub connector of the KCT-60 to the D-sub
15-pin terminal of the transceiver.
3. Connect the 15-pin connector of the KCT-60 to a Horn
alert cable, KCT-18, KES-5, or through a KCT-36 extension
cable.
Note: You must setup using the KPG-135D(K) or KPG-
135D(M).
6
V
( )
REALIGNMENT
] key, the currently selected
Fig. 2

INSTALLATION

6-2. Flow chart (Source transceiver)
Press [ ] key + Power ON for 1 second
Is
password*
set?
* Read
No
Authorization
password
Clone mode
Start the clone funnction

7. Firmware Version Information

Press and hold the [ ] key while turning the transceiver
power ON and then keep pressing and holding the [ ] key,
the fi rmware version information appears on the LCD.
KCT-60
Horn alert cable,
KCT-18, KES-5 or through
KCT-36 extension cable
Yes
Shows CLONE LOCK
Enter password
Is entered
No
password
correct?
Yes
[ ]