Charging The Device; Mounting The Car Holder; Getting Started; Connecting The Gps Device To Pc - Lark FreeBird 35.9 User Manual

Getting to know the device

Charging the device

To charge the battery of the device please place the USB jack of the car charger in the
USB slot of the device. The other end of the charger place in the car lighter jack (make
sure the car electricity is on). The battery will be charging regardless of the fact if the
device is on or off. Red LED on means charging is in progress. When the battery is fully
charged, the LED will turn green.
1. If you are using the device during the charging process, the charging will take
longer.
2. After charging is complete or when you want to stop charging the device, simple
detach the charger's cable from the device.
3. Never crush the battery or throw it to fire! Fire or electric shock hazard!
4. While travelling it is recommended to have the car charger attached to the device
all the time.
5. Please, make sure that the device and the cable do not obstruct the driver's view
of the road and do not interfere with the vehicle operating controls.
Mounting the car holder (vehicle suction mount)
Step 1
Press the rubber part of the mount to the windscreen and move the latch to fasten
the mount.
Step 2
Using the knobs adjust the position of the mount to your needs.
?
When installing the device in your vehicle please make sure it does not obstruct
the driver's view of the road or interfere with vehicle operating controls.
?
Do not place the device unsecured on the vehicle dashboard.
?
Do not place the device on or above any airbag.
Getting started – acquiring satellites' signal
?
When you switch ON the device for the first time, please make sure you are in an
open space, with no large objects near (like tall buildings and trees).
?
Hold the device steadily until the acquisition of satellites' signal. Pls note that
acquiring the satellites can take a few minutes.
?
Than you can set your route.
?
It is always recommended to acquire the GPS signal before placing the device
in the car.

Connecting the GPS device to PC

After installing the ActiveSyc software (see page 17)
connect the GPS device to your PC using the USB
cabel (mini-A USB type). The cable must be obtained
separately, it is not included in the set.
8