Sony VPH-G90U Service Manual page 76

Using the MENU
ALL WHITE MODE
Sets the duration of all white mode during a warm-up
period.
A L L W H I T E M O D E : 2 0 m i n
Use the V, v, B or b key to set the duration in 1
minute increments from 0 to 99 minutes.
To set the projector to display the picture immediately
after the projector is turned on, set the duration to "0
min."
PJ. COM (projector communication)
Sets the communication baud rate for the PJ. COM
terminal to 38.4 K, 19.2 K or 9600.
S I N P U T - A
D I R E C T P O W E R O N : O F F
SET
SETTING2
A L L W H I T E M O D E :
INPUT
INFO. 2 0 m i n
P J C O M : 3 8 . 4 K
SET
INFO
R S - 2 3 2 C / 4 2 2 A : 3 8 . 4 K
SERVICE
SETTING1
SERVICE
SETTING2
SEL: SET: ENTER EXIT: MENU
RS-232C/422A
Sets the communication baud rate for the RS-232C/
422A terminal to 38.4K, 19.2K or 9600.
S I N P U T - A
D I R E C T P O W E R O N : O F F
SET
SETTING2
A L L W H I T E M O D E :
INPUT
INFO.
2 0 m i n
P J C O M : 3 8 . 4 K
SET
INFO R S - 2 3 2 C / 4 2 2 A : 3 8 . 4 K
SERVICE
SETTING1
SERVICE
SETTING2
SEL: SET: ENTER EXIT: MENU
70
Before adjustment
The SERVICE SETTING 3 Menu
(Expert mode)
The SERVICE SETTING 3 is used for the adjustments
performed by the specialized service personnel only.
E I N P U T - A
D E V I C E C O N T R O L
SERVICE
SETTING3
PIC
ORBITING
INT.OSC
SETTING
TIMER
ABL
LINK
SEL: SET: ENTER EXIT: MENU
DEVICE CONTROL
This item is used when the service personnel has
replaced the internal board. Do not use this item
normally.
The PIC ORBITING Menu
(Service/Expert modes)
The PIC ORBITING menu is used to shift the image
on the screen automatically to prevent the CRT burn.
S I N P U T - A
P I C O R B I T I N G : O F F
PIC
ORBITING
INT.OSC
SETTING
S C A N L I N E S H I F T : O F F
TIMER
ABL
LINK
SEL: SET: ENTER
EXIT: MENU
PIC ORBITING
Set to ON to shift the images on the multiple projector
screens regularly to prevent the CRT burn. This mode
is recommended when you project a still picture for a
long time.
S I N P U T - A
P I C O R B I T I N G : O F F
PIC
ORBITING
INT.OSC
SETTING S C A N L I N E S H I F T : O F F
TIMER
ABL
LINK
SEL: SET: ENTER EXIT: MENU
SCAN LINE SHIFT
Set to ON to shift the vertical position of the images on
the multiple projector screens regularly to prevent the
CRT burn. This mode is recommended when you
project a signal with a low horizontal frequency.
S I N P U T - A
P I C O R B I T I N G : O F F
PIC
ORBITING
INT.OSC
SETTING S C A N L I N E S H I F T : O F F
TIMER
ABL
LINK
SEL: SET: ENTER EXIT: MENU
71
Before adjustment