System Setup" Menu; System Reset - Teufel DecoderStation 7 Technical Description And Operating Instructions

Crossover frequency
With the crossover frequency, you define the frequency,
up to which the subwoofer should be active . Possible
values: 80 to 250 Hz in eight steps .
You can also set the edge steepness: This is the level,
which is still present at the subwoofer above the crossover
frequency . Possible values: –24 dB and –36 dB .
Enter –24 dB for normal speakers . For satellite speakers
with bassreflex openings, the acoustic efficiency declines
more sharply — so select -36 dB for optimal actuation of
the subwoofer .
You can find information on the recommended crossover
frequency in the technical data of the satellite speakers in
our webshop .
Distance
The surround sound effect may be corrupted if the speak-
ers are positioned at different distances to the listening
position . To compensate for these differences in run time,
you can set slight signal delays for all channels . Measure
the difference from the listening position to the speakers
and enter these values in the menu . The system calculates
the required delays on this basis .

"System Setup" menu

HDMI
CEC (Consumer Electronics Control)
If this function has been activated (ON), CEC-compatible
devices are controlled with a control command issued via
the HDMI connection . For example, the DecoderStation 7
and the connected devices are automatically activated
and deactivated via the remote control of the TV set .
ARC (Audio Return Channel)
This option offers receiving audio from the TV via the
HDMI cable (for TV sets that support this function) .
Audio from television sets runs to the DecoderStation 7
through the HDMI cable without having to connect
another cable . If the ARC function is activated, the
"COAXIAL 1" input (9) is no longer available .
Possible settings: OFF, ON .
Important!
Please note that many television sets only have
one HDMI input that supports the ARC function .
To use ARC you must also activate CEC .
Note: If the CEC function is activated, standby power
consumption increases .
Automatic deactivation
After a certain time of inactivity, the device automatically
switches to standby after a preset time . Possible values:
60 min . (default), 30 min ., never .
Power On Level
Here you can set the volume of your device when it is
activated:
• last: The volume that was set at deactivating .
• fixed: Fixed volume from -40 dB (low) to +10 dB (very
loud) .
5 . 1 /7 . 1
With this, you can switch between 5 . 1 and 7 . 1 operation
and also set the function of the analogue output 14 "RC/
PRE OUT" (see page 10), which you can connect a stereo
amplifier, active speaker or radio transmission system .
This makes it possible to project sound into another room
or connect to the rear center speakers in 7 . 1 opera-
tion using RF audio transmission system (such as Teufel
Rear Station 4) .
5 . 1 Converts (via downmix) the 5 . 1 audio
signal to a stereo channel (2 .0) to project
sound into a second room .
7 . 1 7 . 1 Operation with output of the additional
rear channels .
D/E
You can set the OSD menu language this way . Possible
values: German, English
The menu in the unit display panel 2 is always in English .

System Reset

This resets the device to the factory default .
• DecoderStation 7 15