Television/Projector; Audio Outputs - Teufel DecoderStation 7 Technical Description And Operating Instructions

OPTICAL
You can connect the optical digital sound output of a
source device to the jack 8 . You will need an optical
cable with a TOSLINK plug for this . Your source requires
either an optical 3 .5 mm jack or a TOSLINK jack, too .
Coaxial 1 and Coaxial 2
You can connect the coaxial digital audio outputs of up to
two source devices to the jacks 9 . You will need a coaxial
cable with RCA plugs for this .
AUX 1, 2 and 3
You can connect source devices with analogue audio
signals to the jacks 11 and 12 . The jack 11 (AUX 1) is a
3 .5-mm jack for connecting e .g . a MP3 player . The jacks
12 (AUX 2 and 3) are RCA jacks for connecting e .g . a
cassette or audio tape player .
If you want to connect a record player, which does not
have a line output, use PhonoStation 1 for correct pre-
amplification .
Outputs

Television/projector

Connect your television set or your projector to the
"HDMI OUT" jack 17 . You will need a HDMI cable for
this .

Audio outputs

Connect your high power amplifier, multi-channel active
subwoofer or active speaker to the RCA jacks 15 . You will
need three stereo RCA cables for this:
FRONT LEFT/RIGHT Front left/right channels
CENTER Mid-channel
SUB Subwoofer channel
SURR LEFT/RIGHT Rear left/right channels
In 7 . 1 operation, the two additional rear channels are
connected to the jacks 14 "RC/Pre Out" (see next para-
graph) .
10
• DecoderStation 7
8 9 11 12
17
15