Headphones; Connecting To A Power Supply - Teufel DecoderStation 7 Technical Description And Operating Instructions

RC/Pre Out
You can configure the function of the analogue output 14
"RC/Pre Out" in the "System Setup" menu . (see "5 . 1 /7 . 1 "
on page 15):
5 . 1 operation Converts (via downmix) the 5 . 1 audio
signal on two stereo channels (2 .0) in
order to, for example, project sound into a
second room .
7 . 1 operation Output of the additional rear channels
(REAR) .
You can connect your power amplifier or multi-channel
active subwoofer, active speaker or a RF audio transmis-
sion system to these jacks . You will need a stereo RCA
cable to do so .

Headphones

You can connect stereo headphones with a 3 .5 mm
phone plug to the "HEADPHONES" jack 13 .
The outputs to the power amplifiers (14and 15) are
automatically deactivated when connecting headphones .
They can, however, be reactivated by pushing button 28
" " on the remote control . This makes it possible to oper-
ate the DecoderStation 7 with the active speakers even
when headphones are inserted (e .g . while using wireless
headphones with transmitter permanently connected) .
Danger Danger of injury/damage!
Lower the volume before you pull out the head-
phone plug again; otherwise the speakers may
emit unexpected high sound pressure . This could injure
your hearing or damage the device .

Connecting to a power supply

• Make sure that your power amplifier, multi-channel ac-
tive subwoofer or the active speakers are turned off .
• Connect the small mains adapter c plug to the jack 19
"12V" .
• Connect the mains adapter c to a mains socket
(100 V–240 V ~ / 50/60 Hz) .
14
13
19
• DecoderStation 7 11