Emergencies; Hazard Warning Lamp; Vehicle Does Not Start - Checks - Mahindra 2016 KUV100 K2 Owner's Manual

13 EMERGENCIES

13.1 Hazard Warning Lamp

The hazard warning lamp switch is located in between the two AC
center vents on the instrument panel. Use the hazard warning lamp
when your vehicle is stationary or to warn other road users to be
cautious while passing your vehicle.
To turn the hazard warning lamp ON, press the switch in. All the
turn signal lamps flash. To turn OFF, press the switch again.
The turn lamps do not work when the hazard warning lamps
are operational.
Hazard lamps are also switched ON during the following
conditions;
© Copyright Mahindra & Mahindra Ltd. 012016

13.2 Vehicle Does Not Start - Checks

Before making these checks, make sure you have followed the
correct starting procedure and that you have sufficient fuel.
If the engine is not cranking or is cranking too slowly/ intermittently
1.
S12H19
2.
3.
4.
• Crash — Hazard would be turned on for 30 mins
• Panic Braking — When the vehicle is running above 100
kmph and panic/sudden brakes are applied, hazard will turn
on for 5 sec
• Vehicle break down warning bonnet open — The vehicle
break down warning would be enabled only when bonnet
switch changes from close to open condition at vehicle
unlocked condition
Pressing the hazard switch twice deactivates this feature.
Check that the battery terminals are tight and clean.
If the battery terminals are firmly fastened, switch ON the
interior lamps.
If the lamps do not illuminate, glow dim or go OFF when the
starter is cranked, then it indicates a weak or discharged
battery. Try jump starting. Follow 'Jump starting' instructions
given later in this chapter.
Check the fuses in the Engine Compartment Fuse Box and
Central Fuse Box.
EMERGENCIES
13-1