Copy Command; Disable Command; Reboot Command - Planet Networking & Communication WGSW-2840 User Manual

clear security static-MAC
clear snmp community
clear snmp trap
clear spantree root
clear trunk
clear vlan
copy config flash
clear port storm-limit
clear qos map cos-queue-map
clear qos map dot1p-cos-map
clear qos map mac-cos-map
clear qos map vlan-cos-map
clear security filter-MAC
clear security static-MAC
clear snmp community
clear snmp trap
clear spantree root
clear trunk
clear vlan

3.5.2.2 Copy command

Once the configuration is changed, it remains the original after a reboot unless the configuration is saved.
Copy command is to save the current configuration to the flash, this saves the configuration to next
reboot.
Command
copy config flash

3.5.2.3 Disable command

Disable command is to exit the privileged mode and back to the first level of command line interface.
Command
Disable

3.5.2.4 Reboot command

Reboot command is to reboot the switch, please beware to check if the configuration is saved..
Command
Reboot
Clear static MAC entry
Clear snmp community entry
Clear snmp trap management host
Restore spanning tree parameters
Clear trunk port from vlans
Clear member from vlan
Copy system configuration parameters to default value
Clear strom limit of all ports
Reset cos-queue map to default
Reset dot1p_cos map to default
Clear qos map mac-cos-map
Clear qos map vlan-cos-map
Clear MAC filter entry
Clear static MAC entry
Clear snmp community entry
Clear snmp trap management host
Restore spanning tree parameters
Clear trunk port from vlans
Clear member from vlan
Description
Copy system configuration parameters to flash
Description
Disable privileged mode
Description
Reboot system