Panasonic Toughbook CF-M34 Series Reference Manual page 14

Security Measures
Setting the user password
1
Run the Setup Utility
NOTE
Set the Supervisor Password if you have not done so. (
2
Using and
3
Using and
4
<Only when the User Password has been set>
Enter your password at the [Enter Current Password], then
press Enter
5
Enter your password at the [Enter New Password], then
press Enter
To disable the User Password
Simply press Enter
NOTE
Your password will not be displayed on the screen.
Limit your password to seven characters. Note that there is no distinction
between upper and lower case letters.
White colored keys can be used. Note that the space bar and function
keys cannot be used.
6
Re-enter your password at the [Confirm New Password] , then
press Enter
To disable the User Password
Simply press Enter
7
At the [Setup Notice], press Enter
8
Press F10 , then select [Yes]
CAUTION
Do not input your password while holding down on Shift or Ctrl .
Use only the upper horizontal row of numeric keys to input your password.
Do not forget your password. If a password is forgotten, you will be unable to
use your computer. Contact Panasonic Technical Support.
When running the Setup Utility, do not leave your computer even for a
short time.
NOTE
When you do not want the User Password enabled, changed, or disabled
without permission:
1 Using and
2 Using and
(enabling, changing, disabling)
( page 32)
, select [Security]
, select [Set User Password], then press Enter
, select [User Password Protection] and press Enter .
, select [Protected] and press Enter .
14
page 13)