Suspend/Hibernation Functions - Panasonic Toughbook CF-M34 Series Reference Manual

Suspend/Hibernation Functions

Starting Up Your Computer Quickly
If you want to immediately start up and continue an application after shutting down
your computer, you can do so by using the suspend or hibernation function.
Differences between the suspend and hibernation functions
Function Suspend function
Where data is saved to Memory
Speed Fast
Requires power supply Yes
Setting the Suspend or Hibernation Function
[Hibernation] is factory set.
1
Run the Setup Utility
2
Using and
3
Using and
4
Using and
press Enter
5
Press F10 , then select [Yes]
NOTE
The Suspend or Hibernation function can be set even with [Panel Switch] in the
Setup Utility.
page 36
Shutting Down Using the Suspend or Hibernation Function
The computer should be set for suspend or hibernation (
dure).
Slide the power switch
(After releasing your finger from the
power switch, do not touch the power
switch until the power indicator goes off
or blinks.)
CAUTION
At the "beep*" sound, release your finger from the power switch. If you con-
tinue to slide the switch and hold it for more than four seconds, the power will
go off. Data not previously saved will be lost.
Even when [Power Switch] is set to [Power Off] with the Setup Utility, if you
slide the switch, a beep will sound and the power will go off if you slide the
switch for more than four seconds.
If the computer will not be operated for an extended period of time, it is recom-
mended that hibernation mode be used instead of the suspend mode.
*
When the speaker function is disabled, e.g., by setting [Disable] for [Speaker] with the
Setup Utility ( page
sound.
(if power is cut, all data is lost)
( page 32)
, select [Power]
, select [Power Switch] and press Enter
, select [Suspend] or [Hibernation] and
33) or by the key combination Fn + F4 , there will be no beep
Hibernation function
Hard disk
Somewhat slow
Power not required to maintain data
see the above proce-
Suspend Mode
or
Hibernation Mode
9