Bluetooth; About The Bluetooth Wireless Technology - Sony MHC-GT3D Operating Instructions Manual

BLUETOOTH

About the BLUETOOTH
wireless technology
BLUETOOTH wireless technology is a
short-range wireless technology that
enables wireless data communication
between digital devices. BLUETOOTH
wireless technology operates within a
range of about 10 meters.
Supported BLUETOOTH version,
profiles and codecs
For details, see "BLUETOOTH section"
(page 62).
Compatible BLUETOOTH devices
For details, see "Websites for
compatible devices" (page 10).
About the BLUETOOTH
indicator
The BLUETOOTH indicator on the
subwoofer lights up or flashes in blue
to show the BLUETOOTH status.
System status
BLUETOOTH standby
BLUETOOTH pairing
BLUETOOTH connection
is established
Pairing this system with a
BLUETOOTH device
Pairing is an operation where
BLUETOOTH devices register with each
other beforehand. Once a pairing
operation is performed, it does not
need to be performed again.
1
Place the BLUETOOTH device
within 1 meter from the system.
40 GB
Indicator status
Flashes slowly
Flashes quickly
Lights up
2
Press BLUETOOTH on the
subwoofer to select BLUETOOTH
function.
"BT AUDIO" appears in the display
panel.
Note
If the system is connected to a
BLUETOOTH device, press BLUETOOTH
on the subwoofer to disconnect the
BLUETOOTH device.
3
Hold down PAIRING on the
subwoofer for 2 seconds or more.
"PAIRING" flashes in the display
panel.
4
Perform the pairing procedure on
the BLUETOOTH device.
For details, refer to the operating
instructions of your BLUETOOTH
device.
5
Select "MHC-GT3D" on the
device's display.
Perform this step within 5 minutes,
otherwise pairing will be canceled.
In this case, repeat from step 1.
Note
If passkey is required on the
BLUETOOTH device, enter "0000".
"Passkey" may be called "Passcode",
"PIN code", "PIN number", or
"Password".
6
Perform the BLUETOOTH
connection on the BLUETOOTH
device.
The BLUETOOTH device name
appears in the display panel.
Depending on the BLUETOOTH
device, connection may start
automatically after pairing is
completed.
You can check the BLUETOOTH
device address by pressing DISPLAY
repeatedly.