Installation; Closing The Door - Zanussi ZFU27401WA User Manual

Problem
Temperature cannot be set.
Door is misaligned or interferes
with ventilation grill.
The temperature in the appliance
is too low/too high.
If the advice does not lead to the
desired result, call the nearest
brand-mark service.

Installation

WARNING!
Refer to Safety chapters.
Positioning
This appliance can be installed in a dry, well
ventilated indoor where the ambient
temperature corresponds to the climate class
indicated on the rating plate of the appliance:
Climate Ambient temperature
class
SN +10°C to + 32°C
24
Possible cause
The FastFreeze or Shopping-
Mode function is switched on.
The appliance is not levelled.
The temperature regulator is
not set correctly.
The food products' tempera-
ture is too high.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened of-
ten.
The FastFreeze function is
switched on.
There is no cold air circulation
in the appliance.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
3. If necessary, replace the defective door
Climate
N
ST
T
Switch off FastFreeze or Shopping-
Mode manually, or wait until the
function resets automatically to set
the temperature. Refer to "Fast-
Freeze or ShoppingMode function".
Refer to "Levelling".
Set a higher/lower temperature.
Let the food products temperature
decrease to room temperature be-
fore storage.
Defrost the appliance.
Open the door only if necessary.
Refer to "FastFreeze function".
Make sure that there is cold air cir-
culation in the appliance.
"Installation".
gaskets. Contact the After Sales Service.
Ambient temperature
class
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
Solution
www.zanussi.com