Advertisement
REMOVING THE BIKE
1. Remove thumb controller from handlebar
2. Loosen the adjustment knob on the resistance unit to back the
roller away from the tire until it no longer touches.
3. Reduce axle tension by loosening the right axle knob a minimum of
two turns to allow for disengagement of the quick release.
4. Firmly grasp your bike seat stay to stabilize the bike.
5. Disengage the quick release on the right side of the trainer and
slide the axle knob to the fully open position. The bike can now be
removed from the left cone cup.
ADDITIONAL BIKE MOUNTING SOLUTIONS
STANDARD CONE CUP
SLOTTED CONE CUP
PART NO: T-2111
PART NO: T-2103
Pre-installed on all Kinetic
Comes in the trainer box
trainers and fits most
and works with many
nutted axles and track
non-Kinetic quick release
bikes.
skewers.
KINETIC TRAXLE FINE
PART NO: T-2100
For fine-threaded 12mm thru-axle systems
including: Syntace X-12, DT SWISS (Tapered
and Flat) and Specialized
ACCESSORIES
(Available at kurtkinetic.com and Kinetic dealers)
RISER RINGS
TRAINER MATS
TRACK CONE CUP
PART NO: T-2104
An oversized version of the
Standard Cone Cup for track
axle nuts larger than 15mm.
KINETIC TRAXLE FINE XL
PART NO: T-2120
Same thread pitch as Fine Traxle, with wider
width. For Santa Cruz bikes with closed
dropout on the drive side -requires removal
of hex cap in drive side dropout.
SWEAT GUARDS
www.kurtkinetic.com
SAFETY WARNINGS
» Be sure that your bike is correctly installed and securely locked
into the trainer before riding.
» Do not over-tighten the roller tension knob. Over-tightening will
cause both tire and unit damage. Tighten only enough to avoid tire
slippage.
» When using the trainer for normal use or for extended periods of time,
the resistance unit will get hot. DO NOT touch the resistance unit
while it is in use or while it is hot.
» Always consult a doctor before beginning any exercise routine or
using any fitness product including the Kinetic Trainer. Should you
become ill, feel dizzy, light-headed or nauseous while riding the
trainer, stop riding immediately and seek medical attention.
» While in use, the wheel of your bike and the resistance unit may be
spinning at high speeds. For this reason keep children, pets and all
items safely away from your trainer while in use.
» Always use the trainer on a flat surface.
» Single-speed bikes with nutted axles require an additional standard
cone cup for proper use.
(Ordering & information: kurtkinetic.com)
SHALLOW CONE CUP
INTERNAL CA CONE CUP
PART NO: T-2105
PART NO: T-2106
Designed with a shallow
Works with chain-actuated
outside diameter to work on
internal hubs like Sturmey
any frame with a tight drive-
Archer. Great for Brompton
side dropout tolerance.
bikes.
KINETIC TRAXLE MEDIUM
PART NO: T-2102
For medium-threaded 12mm thru-axle
systems including: SHIMANO SM-AX75 and
SM-AX65 142mm x 12mm
TRAINER BAGS
BMX CONE CUP
PART NO: T-2107
For oversized 14mm bmx
axles with axle nuts 19mm
and larger.
KINETIC TRAXLE COARSE
PART NO: T-2101
For coarse-threaded 12mm thru-axle
systems including: RockShox Maxle, Trek
APB Maxle and others
TRAINER TIRES
PRO FLYWHEEL
Page 5
Advertisement
