Related Manuals for kinetic T-006 Cyclone
Summary of Contents for kinetic T-006 Cyclone
- Page 1 T-006 ASSEMBLY MANUAL CYCLONE 5280 Main Street NE Minneapolis, MN 55421 1.877.226.7824 | www.kurtkinetic.com...
- Page 2 Bolt and (Installed on trainer) (see www.kurtkinetic.com for installation instructions) Your Kinetic Trainer is designed for use with road, mountain, BMX and ADJUSTABLE FOLDING LEGS recumbent bikes. Before adjusting these legs, you must know your bike’s tire size, which is printed on the sidewall of every tire.
- Page 3 TRAINER DETAILS RISER RING QUICK RELEASE LEVER LOCK RING TENSIONING KNOB LEG BOLT FLYWHEEL RESISTANCE UNIT ADJUSTMENT KNOB Page 3 www.kurtkinetic.com | 1.877.226.7824...
- Page 4 ATTACH RESISTANCE UNIT Fasten resistance unit with mounting bolt and nut PART F Place L-Bolt in frame sleeve as shown PART C Page 4 www.kurtkinetic.com | 1.877.226.7824...
- Page 5 ATTACH RESISTANCE UNIT Slide spring over L-Bolt PART D Tilt the resistance unit up toward the frame while directing L-bolt into the hole in the yoke. Attach adjustment knob and washer. PART E Page 5 www.kurtkinetic.com | 1.877.226.7824...
-
Page 6: Right Side
MOUNTING BIKE Grip frame at seat stay Loosen lock ring and Turn knob to center bike At this point, be sure that resistance unit is loosely tightened and does not touch tire. Push knob QUICK tight against RELEASE skewer, close quick release and tighten knob until tire... -
Page 7: Left Side
2 to 5 more turns. RECOMMENDED SKEWER AND CONE COMBINATION* BIKE REMOVAL To properly remove the bike: KINETIC SKEWER 1. Turn the adjustment knob (included with trainer) on the resistance unit counterclockwise to back the PART M roller away from the tire until it is no longer touches. -
Page 8: Warranty
It is the responsibility of the purchaser to file a warranty card via mail be provided with a Return Material Authorization Number and procedures for or on-line with Kinetic in the event that repairs are needed. It is also the returning your product to Kinetic.