Related Manuals for kinetic ROCK AND ROLL T-016
Summary of Contents for kinetic ROCK AND ROLL T-016
- Page 1 T-016 ASSEMBLY MANUAL ROCK AND ROLL 5280 Main Street NE Minneapolis, MN 55421 1.877.226.7824 | www.kurtkinetic.com...
- Page 2 COMPONENTS Tools Required for Assembly: 17mm Wrench or Adjustable Wrench When unpacking, check that the following components are present: PLEASE NOTE: If any of the components listed are missing, please call our Customer Service hotline at 877-226-7824. Part A-2 Bottom Frame Center Piece Part A-3 Part A-1...
- Page 3 TRAINER DETAILS TURNTABLE RISER RING THREADED CONE CUP QUICK RELEASE LEVER LEFT CONE CUP LOCK RING LEFT ADJUSTMENT KNOB RESISTANCE UNIT LEG BOLT ROLLER TENSION KNOB TRAINER TENSION BOLTS Page 3 www.kurtkinetic.com | 1.877.226.7824...
-
Page 4: Frame Assembly
FRAME ASSEMBLY Lay out the leg extenders and the bottom frame center piece and insert extenders. Leg extenders can be twisted slightly before tightening to level trainer base to floors. PART A-3 PART A-2 Tighten with 4mm allen key Page 4 www.kurtkinetic.com | 1.877.226.7824... - Page 5 FRAME ASSEMBLY Position top frame piece over the base and align tension bolts to the holes in the base. PART A-1 NOTE: If available, Lubricate tension-bolt threads with chain lube, spray lube, or light oil. PROPERLY SEATED ELASTOMERS 2 TO 5 TURNS PAST SNUG Tighten both tension bolts (left) until elastomer stack (above) is fully seated.
- Page 6 ATTACH RESISTANCE UNIT Fasten resistance unit with mounting bolt and nut PART F PART C Place L-Bolt in frame sleeve as shown Page 6 www.kurtkinetic.com | 1.877.226.7824...
- Page 7 ATTACH RESISTANCE UNIT Slide spring over L-Bolt PART D Tilt the resistance unit up toward the frame while directing L-bolt into the hole in the yoke. Attach adjustment knob and washer. PART E Page 7 www.kurtkinetic.com | 1.877.226.7824...
- Page 8 MOUNTING BIKE Grip frame at seat stay Loosen lock ring and Turn knob to LEFT center bike CONE THREADED CONE CUP Thread out to center bicycle on roller At this point, be sure that resistance unit is loosely tightened and does not touch tire.
-
Page 9: Bike Removal
2 to 5 more knob if needed. turns. RECOMMENDED SKEWER AND CONE COMBINATION* BIKE REMOVAL To properly remove the bike: KINETIC SKEWER 1. Turn the adjustment knob (included with trainer) on the resistance unit PART M counterclockwise to back the roller away from the tire until it is no longer touches. -
Page 10: Warranty
It is the responsibility of the purchaser to file a warranty card via mail be provided with a Return Material Authorization Number and procedures for or on-line with Kinetic in the event that repairs are needed. It is also the returning your product to Kinetic.