GE 20 Use And Care Manual page 6

ELECTRO~C MO~OR & DWGNOSTIC SYSTEM
(continued)
How the Electronic Monitor and Diagnostic System Works
The Electronic Monitor and Diagnostic System alerts you when
This pad is lighted except when a
something starts to go wrong.
failure has been detected.
If a diagnostic code appears on the display, something needs
special attention. To get your attention, the display code flashes
until you erase it, The first 6 flashes are accompanied by b~ps.
. .
\
J
If more than one coded function requires attention at the same
time, the one with the highest priority will be displayed first.
This pad has two functions:
Pressing this pad will evaluate all other coded
1. You can touch this pad and get a review of the
functions. If the ~ display is lit during the displaying
( )
electronic diagnostic codes in order of their priority.
1 f) d
of a code, that function is operating properly.
Pressing this pad will erase two codes immediately—
PF and CI. The dE and FF codes can only be erased
after the condition that caused the code to flash has
been corrected.
M
2. You can touch this pad to erase three flashing codes
Y
immediately and two codes after the condition that
u
caused them to flash has been comected.
This flashing code tells you to check your
frozen food. Has any of it started to thaw? A
package may be holding the freezer compartment
door open. Don't open the door more often than
absolutely necessary while this code is displayed.
Touching the @ pad after the freezer compartment
temperature has returned to normal will erase
the code.
This flashing code tells you the power to the
refrigerator has been interrupted for more than
two seconds. Check the condition of food in both
the fresh food and freezer compartments. Touch the
@ pad to erase code.
There is no fault with the refrigerator when the
PF code flashes.
This flashing code tells you to check the
automatic icemaker. Ice clumps in the storage
bin may have stalled the icemaker. Follow
corrective measures described in the Problem
Solver. If water supply to the icemaker is not
connected or not turned on, make sure manual
icemaker switch is in the 0 (up) position, This
code stops flashing when problem is corrected or
the @ pad is touched.
This flashing code tells you something is wrong
with the defrost system—keep doors closed to
retain cold and call for service. Code flashes until
problem is corrected.
6