Delete User - Anviz M5 Quick Manual

Operation Guide
Add Two Fingerprints and Card of one User:
* The wiegand output of fingerprint and card are the same.
Note: 1. After finish
enrolling current user,
please swipe enroll card and
then continue register
another user.
2. After finish
enrollment, please
swipe enroll card
TWICE to exit enroll
status.
1. Swipe
Enroll Card

Delete User:

Delete Fingerprint or Fingerprint and Card
After delete one user, you can continue to delete
another user or swipe Delete Card to save and exit.
When fingerprints or card belong to one user
ID, you can delete either one to delete this
user.
Notice:
When you place finger on M5, Red LED flashing
with long beeps means the fingerprint does not
exist in the device.
10. Continue to register another user
4. Continue to register the 2nd finger
2/5. Place finger 3/6. Place finger
again
Blue LED
Blue LED
flashes
flashes fast and
FingerPrint
sensor lights up
1. Swipe
Delete Card
7. Swipe
User Card
Green LED lights up Blue LED
with 4 short beeps, flashes fast and
registration FingerPrint
successed sensor lights up
4. Continue to delete
2. Place finger
Red LED
Red LED flashes
flashes
fast and
FingerPrint
sensor lights up
8. Swipe User
9. Swipe
Card again
Enroll Card
once
1
Green LED lights up
with 4 short beeps,
registration
successed
3. Place finger
again
Green LED lights up
with 4 short beeps,
registration
successed
Exit
Enrollment
11. Swipe
Enroll Card
TWICE to end
the
enrollment
2
5. Swipe Delete
Card to end
the process
8