Register User; Operation Guide - Anviz M5 Quick Manual

Operation Guide

IMPORTANT:
M5 is suitable for vehicle with DC12V power supply only. When connect to DC12V power supply, the indicator light
displays blue and flashes fast. Meanwhile, the backlights of fingerprint sensor turn on with beeps.

Register User:

Add One Fingerprint per User Only:
Note: 1. After finish enrolling current user,
please swipe enroll card and then continue
register another user.
2. After finish enrollment, please swipe
enroll card TWICE to exit enroll status.
Notice:
When you place finger on M5, Red LED flashing
with two long beeps means the finger has been
registered.
Add Card Only:
Note: 1. After finish enrolling current user,
please swipe enroll card and then continue
register another user.
2. After finish enrollment, please swipe
enroll card TWICE to exit enroll status.
Notice:
When you swipe card on M5, Red LED flashing
with two long beeps means the card has been
registered.
5. Continue to register another user
2. Place finger
1. Swipe
Enroll Card
Blue LED
Blue LED flashes fast
flashes
and fingerprint
sensor lights up
5. Continue to register another user
2. Swipe
User Card
1. Swipe
Enroll Card
Blue LED Blue LED flashes
flashes fast and
FingerPrint
sensor lights up
3. Place finger 4. Swipe Enroll
again Card once
1
Green LED lights up
with 4 short beeps,
registration successed
3. Swipe User 4. Swipe Enroll
Card again Card once
Green LED lights up
with 4 short beeps,
registration
successed
Exit
Enrollment
6. Swipe Enroll
Card TWICE to end
the enrollment
2
Exit
Enrollment
1
6. Swipe Enroll Card
TWICE to end the
enrollment
2
6