Anviz M5 Quick Manual

Outdoor fingerprint & card reader/controller
Hide thumbs Also See for M5:

Advertisement

M5
Outdoor Fingerprint & Card
Reader/Controller
Quick Guide
V1.0

Advertisement

Table of Contents
loading

Summary of Contents for Anviz M5

  • Page 1 Outdoor Fingerprint & Card Reader/Controller Quick Guide V1.0...
  • Page 2: Package List

    Package List RELAY DELAY PROGRAM 12V-I PROGRAM MODE - (YELLOW) 12V-O NORMAL MODE - (BLUE) Screws RJ45 SC011 Note: Outdoor Fingerprint & Card Reader/Controller 1. Please check if the package contains all the Quick Guide V1.0 items listed above. Contact the distributer if Outdoor Fingerprint &...
  • Page 3: Incorrect Method

    Illustration for placing finger Correct method ( Straighten your finger and then place it on the sensor. Ensure the finger is flat and covers the entire sensor window) Always place finger in Try to place your finger covers the entire sensor window. the center of the sensor.
  • Page 4: Installation Diagram

    Steps: Step1: Drill holes in the wall follow the hole position on back panel. Step2: Install and fix back panel, connect related cables. Step3: Place M5 on back panel, fix screw at the buttom of M5. Step3 Appearance 1.36in. 1.97in. (50mm) (34.5mm)
  • Page 5: Wiring Instruction

    Green ⑤ Wiegand DATA1 Output ⑥ White Wiegand26 Output ⑦ Blue Anviz Wiegand Switch Black ⑧ ⑨ Status LED Light Blue ⑩ Important notice: Please carefully follow this wiring instruction. Any damage caused by incorrect wiring is not covered by warranty.
  • Page 6: Function Button

    4 short beeps Communication Communication with M5 via USB port: If management cards are registed,indicator light turns yellow and flashes.You must verify any management card first. If no management card is registed, you can communicate with M5 directly.
  • Page 7: Register User

    Operation Guide IMPORTANT: M5 is suitable for vehicle with DC12V power supply only. When connect to DC12V power supply, the indicator light displays blue and flashes fast. Meanwhile, the backlights of fingerprint sensor turn on with beeps. Register User: Add One Fingerprint per User Only: Note: 1.
  • Page 8 Operation Guide Add Two Fingerprints of one User: 8. Continue to register another user * Two fingerprints belongs to one user ID. 4. Continue to register the 2nd finger Note: 1. After finish enrolling current user, 2/5. Place the 3/6. Place the 1st/2nd 7.
  • Page 9: Delete User

    Card to end user. the process 1. Swipe Notice: Delete Card When you place finger on M5, Red LED flashing Red LED Red LED flashes Green LED lights up with long beeps means the fingerprint does not flashes fast and with 4 short beeps, exist in the device.
  • Page 10: Delete All Users

    Notice: fast and with 4 short beeps, FingerPrint registration successed When you swipe card on M5, Red LED flashing sensor lights up with long beeps means the card does not exist in the device. Delete All Users Delete all uses fingerprints and cards, the device parameter setting do not change.
  • Page 11: One Year Limited Warranty

    One Year Limited Warranty Anviz Global Inc., (the “company”) warrants to the original Items not covered by this warranty: purchaser that the Company’s products for one (1) year from (1) Shipping and freight expenses required to return the the date of purchase to be free of structural and mechanical Company.
  • Page 12 For more information, visit www.anviz.com, or email us press@anviz.com. 2014 © Anviz Global. All Rights Reserved.

Table of Contents