Table of Contents
Advertisement
Changing the speed by adopting the current speed () - requirements
The ACC is activated.
The vehicle is moving at a speed other than that which is stored.
Note
If during control the speed is increased by pressing the accelerator, control is
■
temporarily stopped. Upon releasing the accelerator, control is automatically
resumed.
If during control the speed is reduced by applying the brake, control is stop-
■
ped. Control needs to be restarted in order to resume
If the vehicle is controlled by a lower speed than the stored speed, then
■
the current speed is stored the first time the key is pressed. Press the key
again and the speed is reduced in increments of 1 km/h.
Set the clearance level
Read and observe
on page 163 first.
The proximity to the vehicle ahead can be set with the lever
page 165 or in the Infotainment
»
Vehicle settings.
Setting by means of the lever
›
Set the switch to the spring-loaded position
page 165.
The display of the instrument cluster shows line
which indicates the proximity.
›
Using the switch set line
Note
If the proximity is changed in infotainment, the change will only come into
■
effect after a subsequent activation of the ACC.
The proximity is dependent on the speed. The higher the speed, the greater
■
the proximity to the vehicle ahead.
On wet roads, a longer time interval to the vehicle ahead should always be
■
selected than on dry roads.
» page
166.
» Fig. 204
Owner´s Manual Infotainment, chapter CAR -
or to
» Fig. 204
-
» Fig. 202
on page 164,
2
on the lever to the desired distance level.
2
Special driving conditions
Fig. 205 Special conditions: Cornering / narrow vehicles or vehicles trav-
elling side by side
on
on
Fig. 206 Special conditions: Lane changes of other vehicles / stationary
vehicles
Read and observe
The following and similar situations require special attention of the driver.
When cornering
When driving around long bends the ACC may respond to a vehicle in the adja-
cent lane
» Fig. 205
hicle and will no longer respond to the vehicle ahead.
In such cases, control should be disabled by accelerating, applying the brake or
pressing the button on the operating lever
on page 163 first.
- . Your own vehicle is regulated with respect to this ve-
» Fig. 204
on page 165.
167
Assist systems
Advertisement
Chapters
Table of Contents
