Password Screen; Time Setting Screen - ZyXEL Communications PLA4231 User Manual

Chapter 13 Maintenance
The following table describes the labels in this screen.
Table 31 Maintenance > General
LABEL
Administrator
Inactivity Timer
Apply
Cancel

13.4 Password Screen

It is strongly recommended that you change your PLA4231's password.
If you forget your PLA4231's password (or IP address), you will need to reset the device. See
Section 13.8 on page 93
Click Maintenance > Password.
Figure 61 Maintenance > Password
The following table describes the labels in this screen.
Table 32 Maintenance > Password
LABEL
Old Password
New Password
Retype to Confirm
Apply
Cancel

13.5 Time Setting Screen

Use this screen to configure the PLA4231's time based on your local time zone. To change your
PLA4231's time and date, click Maintenance > Time. The screen appears as shown.
88
DESCRIPTION
Type how many minutes a management session can be left idle before the session times
out. The default is 5 minutes. After it times out you have to log in with your password
again. Very long idle timeouts may have security risks. A value of "0" means a
management session never times out, no matter how long it has been left idle (not
recommended).
Click Apply to save your changes back to the PLA4231.
Click Cancel to reload the previous configuration for this screen.
for details
DESCRIPTION
Type the default password or the existing password you use to access the system in
this field.
Type your new system password (up to 30 characters). Note that as you type a
password, the screen displays an asterisk (*) for each character you type.
Type the new password again in this field.
Click Apply to save your changes back to the PLA4231.
Click Cancel to reload the previous configuration for this screen.
PLA4231 User's Guide