Guide To Network Environment - Probe PID-P200HT Instruction Manual

Guide to Network Environment

Please configure the IP Dome Camera at the location of its installation. You must determine your
network scenario in order to configure the IP Dome Camera with the proper TCP/IP settings. This
tutorial will guide you through the process. Before actually configuring the IP Dome Camera,
determine what settings you will apply. Record those settings that you will use to configure your IP
Dome Camera for reference.
When configuring your IP Dome Camera, treat the IP Dome Camera as another PC on your network.
You will assign it several addresses and other TCP/IP properties to match your current network.
This step-by-step tutorial will teach what IP addresses and network configurations you should assign
your IP Dome Camera based upon your network scenario.
① Before you begin, you will need to locate any information and settings that you have received
from your Internet Service Provider (ISP). You may need to refer to these IP addresses at a later
time during the configuration.
 If you were not given any IP addresses or the ISP was responsible for the setup and
installation of your Internet connection on your PC or network, then please go to step 2
 If you are not using a router on your network, your "Current TCP/IP Settings" (from the
previous section) and "Assigned IP Addresses from My ISP" will be exactly the same
IP Address
Subnet Mask
Default Gateway
Primary DNS Server
Secondary DNS Server (Option)
② You must determine whether the IP address that you were assigned from the ISP is STATIC,
DYNAMIC, or using PPPoE. At this moment, you are only concerned about the ISP. Did they
provide you with a STATIC, DYNAMIC, or PPPoE address? If you are unsure, please contact your
ISP.
③ Configure your IP Dome Camera's TCP/IP settings for network connectivity by selecting
Administration Tools from the main interface and selecting TCP/IP located on the left of the
Administration Tools screen.
④ If prompted for an ID and Password, use "admin" for both entries.
The default web port number is 80. If your ISP blocks port 80 you must use a value between
1025-30000. Please consult your ISP and determine if they block TCP port 80.
ANTIVANDAL IP DOME CAMERA
Assigned IP Address
NETWORK SETUP
4
Static

Dynamic 
PPPoE

22/64