Network Setup; Initial Setup Via A Crossover Cable - Probe PID-P200HT Instruction Manual

Initial Setup via a Crossover Cable

This section provides a guide on how to connect the IP Dome Camera to your PC/laptop for initial setup.
Please follow the instructions in the order they appear, without skipping steps. Do not supply power to
the IP Dome Camera, until instructed.
In order to access the IP Dome Camera's firmware you will need to connect the IP Dome Camera
directly to a PC or laptop computer via the supplied crossover cable and RJ45 coupler.
① Before you begin, you must determine the current network/INTERNET (TCP/IP) settings on the
PC or laptop you plan to setup the IP Dome Camera. Jot down your entries below for quick
reference.
 For information on how to determine your currents settings, see Appendix A
② In order for the IP Dome Camera to communicate with your PC, you have to change your PC's
IP address and subnet mask
 We recommend that you change your IP address to 192.168.1.11 and change the subnet
mask to 255.255.255.0
Leave all other entries (Default Gateway, DNS Servers, etc.) blank.
 For information on how to change your IP address and subnet mask, see Appendix B
③ After you have made the changes to your IP address and subnet mask, you may then attach the
IP Dome Camera to your PC via the supplied crossover cable and RJ45 coupler. Plug-in either
end of the crossover cable into the PC's network card and the other end into your IP Dome
Camera.
④ After connecting the PC and IP Dome Camera using the crossover cable, power on the IP
Dome Camera.
⑤ No longer than 5 minute after powering on the IP Dome Camera, verify that the ACTIVE
indicator light is flashing, and the LINK indicator light is flickering or solid. If they are not,
please read the FAQ.
ANTIVANDAL IP DOME CAMERA
Current TCP/IP Settings
IP Address
Subnet Mask
Default Gateway
Primary DNS Server
Secondary DNS Server (Option)

NETWORK SETUP

4
18/64