AT&T HS-8270 User Manual page 13

FEATURE SETUP
Change Remote Access Code
Change the code you use to access features and functions of the answering
system from a touch tone phone. The Remote Access Code comes set to 500.
NOTE: Do not use the same code as the Priority Calling Code.
Press 9 (SETUP) until the system announces "Remote access
1
code is...."
Press 4 (REPEAT) or 6 (SKIP) to change the first digit, then press
2
9 (SETUP) to move to the next digit. Repeat for second and third
digits.
Press 9 (SETUP) when your choice is announced and displayed.
3
Priority Call Signal
When a caller enters the Priority Calling Code from a touch tone phone,
the system "chirps" to alert you that you have a Priority Call. You'll need to
provide select callers with the Priority Calling Code (preset to 999) in
order for them to use this feature.
1
Your caller dials your telephone number from a touch tone phone.
2
When the announcement begins to play, your caller can enter the
Priority Calling Code.
3
The system "chirps," then pauses. This continues for up to 30
seconds, unless you answer the phone, or the system picks up
the call.
If you do not answer, your caller can press 5 to stop the Priority
4
Call signal.
The caller can press 1 or 2 to leave a message in Mailbox 1 or
5
Mailbox 2.
Change Priority Calling Code
Change the code a caller enters to alert you that you have a Priority Call.
The Priority Calling Code comes set to 999.
NOTE: Do not use the same code as the Remote Access Code.
Press 9 (SETUP) until the system announces "Priority Calling
1
Code is...."
Press 4 (REPEAT) or 6 (SKIP) to change the first digit, then press
2
9 (SETUP) to move to the next digit. Repeat for second and third
digits.
Press 9 (SETUP) when your choice is announced and displayed.
3
12