Controller Output; Restore Factory Setting - Medeli SP3000 Onwers Manual

aw_SP3000_Manual_G04_150723.ai 24 2015/7/23 11:20:12 aw_SP3000_Manual_G04_150723.ai 24 2015/7/23 11:20:12
MIDI Function
You can refer to above procedures 3-6 to complete parameter settings of
controller 1/2/3. Press [MIDI EDIT] button to exit MIDI controller edit
mode, and the relevant indicator will go out.
Note:
1) The command value will be the DATA 1 of Bn if it is within the range
of 0-127 you set, then the value of DATA 2 can be set by pressing
[DATA] button.
2) If the number you set is 128, it can be the command Cn, then the
data value can be set by pressing the [DATA] button.
3) If the number you set is 129, it can be the command Dn, then the
data value can be set by pressing the [DATA] button.
4) If the number you set is 130, it can be the command En, the value
of DATA 2 can be set by pressing the [DATA] button and the DATA 1
will be automatically generated by DATA 2:
If Data2 = 0~126, then Data1=0;
If Data2 = 127, then Data1=127;
In addition:
If Data1=Data2=0, that means the pitch bend is in the lowest level;
If Data1=0，Data2=64, that means the pitch bend is in the middle
level;
If Data1=127，Data2=127, which means the pitch bend is in the
highest level.
C

Controller Output

M
1.
Press and hold the [SHIFT] button, then press the [MIDI MODE]
button to enter the MIDI controller mode, the LED indicator of
Y
[MIDI MODE] lights up.
CM
MY
2.
Press the [CTRL 1] button, the LED indicator of [CTRL 1] will keep
CY
flashing briefly, it represents the system is transmitting MIDI
information of controller 1. Then the relevant MIDI indicator lights
CMY
up when the transmit process is complete. If you press the
K
[CTRL 1] button again, the MIDI information will be repeatedly
transmitted.
3.
In the same way, press the [CTRL 2] and [CTRL 3] button, the MIDI
information of corresponding controller will be transmitted from the
MIDI OUT.
4.
In the MIDI controller mode, if you want to exit, press and hold the
[SHIFT] button, then press the [MIDI MODE] button.

Restore Factory Setting

In shutdown mode, press and hold [+/YES] and [-/NO] buttons together,
then turn the piano on, the system will be restored to factory setting, and
delete all recorded data, meanwhile the nixie tube displays "---". After the
delete process is complete, the piano will be restored to the state of
power-on automatically. Please be careful.
24