Charging / Discharging Lixx Batteries - GRAUPNER ultra duo plus 80 Operating Manual

Before starting a process please ensure that all parameters are set correctly to match your battery type, and that the battery is connected correctly to the
charge output and the balancer. Use the INC or DEC button to move the Select arrow to the appropriate line: storage charge (STORE MODE START),
charge (CHG) or discharge (DCHG). With a brief press on the ENTER button you can run through all the parameters of the selected mode once more,
and adjust them if necessary. Start the process by holding the ENTER button pressed in for two seconds.

using the INC or DEC button.
Pressing the MODE or ESC button switches between the various charge displays. If you wish to halt the charge process, hold the ESC button pressed
in for two seconds.
Hold the ENTER button
pressed in for 2 sec. to
start the charge process.
11] LiPo 3S 2200mAh

STORE MODE START
CHG. : 2.1 A 4.20V/C
DCHG. : 10.0A 3.0V/C
ENTER
0 ] NiMH 6S 3300mAh

CYCLE : C->D 1x 10m
CHG. : 3.3A 5mV/C
DCHG. : 5.0A 0.8V/C
C-TCS: 15% 0:00:12
CAPACITY : 10mAh
Mode
VOLTAGE : 7.612V
CURRENT : 2.20A
0 ] NiMH 6S 3300mAh

CYCLE : C->D 1x 10m
CHG. : 3.3A 5mV/C
ESC
DCHG. : 5.0A 0.8V/C
Operating Manual ULTRA DUO PLUS 80

15. Charging / discharging LiXX batteries

[ LiPo ] CHARGE
*** BATTERY ***
*** CHECK ***
0 ] NiMH 6S 3300mAh

CYCLE : C->D 1x 10m
CHG. : 3.3A 5mV/C
DCHG. : 5.0A 0.8V/C
C-TCS: 15% 0:01:25
INPUT VOLT : 14.222V
Mode
PEAK VOLT : 7.612V
AVG. VOLT : 0.000V
0 ] NiMH 6S 3300mAh

CYCLE : C->D 1x 10m
CHG. : 3.3A 5mV/C
ESC
DCHG. : 5.0A 0.8V/C
ESC
END
CHARGE
Press the 'Inc' or
'Dec' button to
display the
appropriate line.
C-TCS: 15% 0:02:59
BAT. TEMP. : 22.1°C
Mode
PEAK TEMP. : 22.1°C
BATTERY RES: 30mΩ
0 ] NiMH 6S 3300mAh

CYCLE : C->D 1x 10m
CHG. : 3.3A 5mV/C
ESC
DCHG. : 5.0A 0.8V/C
Hold the ENTER
button pressed in
for 2 sec. to stop
the charge process
2S= 7.687V 1S=3.845V
1
13.84V
2
13.84V
1
5mV
0 ] NiMH 6S 3300mAh

CYCLE : C->D 1x 10m
CHG. : 3.3A 5mV/C
DCHG. : 5.0A 0.8V/C
21