Assembling The Spray Guard (142R); Connecting Throttle Cable And Stop Switch Wires; Cable Adjustment - Husqvarna 132R User Manual

Assembling the spray guard (142R)

(Install the cord cutter and guard extension to the spray
guard.)
1) Fasten the cord cutter
(A) to the spray guard
with two M5 x 25
screws, lock washers
and hex nuts as
shown.
2) Attach the guard
extension (B) to the
guard with the five
M5 x 15 screws,
washers and hex nuts
as shown.
Connecting throttle cable and stop
switch wires
1) Insert the throttle cable
through the cable
adjuster sleeve on the
carburettor bracket.
Make sure the end of
the throttle cable
housing is seated
positively in the sleeve.
2) Position the slotted
fitting on the carburet-
tor so the recessed hole
(A) is away from the
cable adjuster sleeve.
3) Rotate the carburettor
throttle cam and slip the
throttle cable through
the slot in the slotted
fitting, making sure the
cable lug drops into the
recessed hole.
4) Operate the throttle
trigger a few times to
make sure that it works
correctly.
5) Plug the stop switch
wires into the matching
connectors from the
engine. Note that wire
polarity is not impor-
tant.
ASSEMBLY

Cable adjustment

• Throttle cable should be paralleled to flexible shaft. In case
of twisting, they should be restored by parallel.
• Throttle cable should be adjusted under the bended flexible
shaft.
1)Loosen the lock-nut (C)
and adjust the cable
adjuster sleeve (D) so the
stop on the carburettor
throttle cam just contacts
the throttle stop and the
cable position keep 1–2
mm play between cable lug
and slotted fittings when
the throttle trigger is fully
depressed.
2)When the throttle cable is
adjusted correctly, tighten
the lock-nut.
1-2mm
19
English –