Unit Front Panel / Rear Panel Callouts - Apogee DLX24 User Instruction Manual

1. USB Connection - A Type-B USB Connector is used to connect the DLX24 direct to a PC and perform the
unit management and control via System Control Manager software.
2. Input Signal/CLIP LED Indicators - The LED indicator for each INPUT allows to visualize the presence
of audio signal (GREEN), approaching CLIP (ORANGE), or CLIP (RED).
3. Output Signal/CLIP LED Indicators - The LED indicator for each OUTPUT allows to visualize the
presence of audio signal (GREEN), approaching CLIP (ORANGE), or CLIP (RED).
4. Power ON Indicator - LED Indicator lights up when the device is powered ON.
5. Power Switch - ON/OFF Main Power Switch for the unit.
6. IEC Inlet and Fuse - AC/Main Connection with an access to fuse. Due to the switched mode power
supply, the operating voltage range is 100V–240V AC, with a frequency between 50 Hz and 60 Hz.
IMPORTANT: Before powering up the unit, make sure that the DLX24 is correctly connected to ground in
an installation that complies with local regulations.
7. Remote Connectors - The A and B remote connectors allow you to simultaneously control the volume
of one or multiple inputs, or one or multiple outputs through a 10k-ohm potentiometer (0-10V DC). The
Inputs or Outputs controlled from each REMOTE port are configured with System Control Manager
application software
8. Output Signal Connections - The DLX24's Signal Output is performed through four balanced outputs
(OUTPUT 1-4), on 3-pin male XLR connectors. Connectors are configured with Pin 1 to Ground, Pin 2 to
Signal + (Positive) and Pin 3 to Signal – (Negative).
9. Input Signal Connections - The DLX24 has two balanced Audio Inputs (INPUT 1 and INPUT 2) on 3-Pin
female XLR connectors configured with Pin 1 to Ground, Pin 2 to Signal + (Positive) and Pin 3 to
Signal – (Negative).
4. Unit Panel Callouts
DLX24 Front Panel
DLX24 Rear Panel
3