Remote Control; Battery Installation - KeepRite ProComfort DLFAHH/DLCAHB Owner's Manual

REMOTE CONTROL

CAUTION
!
EQUIPMENT DAMAGE HAZARD
Failure to follow this caution may result in equipment damage.
Handle the control with care and avoid getting the control wet.
NOTE: To switch between _C and _F, push the "MODE" and
"- " button simultaneously while the remote controller is off.
IMPORTANT: The remote control can operate the unit from a
distance of up to 25 ft. (7.6 m) as long as there are no obstructions.
This is one way communication only (from remote control to fan
coil).
The remote control can perform the following basic functions:
S Turn the system ON and OFF
S Select operating mode
S Adjust room air temperature set point and fan speed
S Adjust airflow direction

Battery Installation

Two AAA 1.5 v alkaline batteries (included) are required for
operation of the remote control.
To install or replace batteries:
1. Slide the back cover off the control to open the battery
compartment.
2. Remove old batteries if you are replacing the batteries.
3. Insert batteries. Follow the polarity markings inside the
battery compartment.
4. Replace battery compartment cover.
NOTE:
1. When replacing batteries, do not use old batteries or a different
type battery. This may cause the remote control to malfunction.
2. If the remote is not going to be used for several weeks, remove
the batteries. Otherwise battery leakage may damage the remote
control.
3. The average battery life under normal use is about 6 months.
4. Replace the batteries when there is no audible beep from the
indoor unit or if the Transmission Indicator fails to light.
REMOTE CONTROL MATCHING
The System require the wireless remote controller to be matched to
the indoor High wall unit before beginning any operations, otherwise
the indoor High wall unit will not accept commands from the remote
controller. Follow the instructions below to automatically match the
remote controller to the indoor high wall unit:
1. Turn on electrical power to the indoor and outdoor units.
The indoor high wall unit powers up in the Off (or Standby)
mode.
2. Hold the remote controller 5 to 6 feet from the indoor high
wall unit.
3. Point the remote controller at the indoor wall unit and press
the Blank button for 3 seconds.
4. The indoor high wall unit provides 3 beeps to signal a
successful match.
5. Press the Power ON button on the remote controller. The
green indicator light displays on the indoor high wall unit.
6. The remote controller is matched and ready for use. If the
indoor unit and remote controller fail to match, check the
remote controller batteries, move closer and repeat the
matching process again.
NOTE: This is a one- time requirement only. The remote
controller and indoor high wall unit need to be successfully
matched only once.
Remote Control Operation - Quick Start
NOTE: When transmitting a command from the remote control to
the unit, be sure to point the control toward the LED display on the
front panel of the unit. The unit confirms receipt of a command by
sounding an audible beep.
1. Turn the unit on by pushing the ON/OFF button.
2. Select the desired mode by pushing the mode button.
3. Select the temperature set point by pointing the control
toward the unit and pressing the "+" or "- " temperature set
point buttons until the desired temperature appears on
screen.
A08299
4. Select the desired fan speed by pressing the FAN SPEED
button to select desired fan speed.
NOTE: If unit is operating in Dry mode (X- FAN), low fan speed
will be displayed and the fan speed cannot be changed.
5. Set the airflow direction. When the unit is turned on, the
louvers default to the cooling or heating position. The user
can adjust the default louver position by pushing the
"SWING" buttons. For details on operating the SWING
louvers, refer to the Remote Control Functions section.
5
Fig. 4 - Modes