Cabela's 860-0010 Assembly & Operating Instructions page 26

Rotisserie motor will not turn.
Grill only heats to 200-300 degrees.
Grill takes a long time to preheat.
Burner flames are not light blue.
• Ensure the motor is connected to a properly grounded
power supply.
• Ensure the on/off switch is in the on position.
• Ensure that the spit is fully inserted into the rotisserie
motor.
• Ensure that the load does not exceed the 40 pound
operational capacity.
• Ensure that there is no encumbrance or drag.
• Check to see if the fuel hose is bent or kinked.
• Make sure the grill area is clear of dust.
• Make sure the burner and orifices are clean.
• Check for spiders and insects.
• The regulator has a safety device that restricts the flow of
gas in the event of a leak. This safety device can be
triggered with out a gas leak. To reset the safety device,
turn off all burners and close the LP tank valve. Disconnect
the regulator from the LP tank and wait one minute.
Reconnect the regulator to the LP tank and slowly open the
LP tank valve until the valve is fully open. Light all burners
and observe the temperature.
• Normal preheat 500-600 degrees, takes about 10-15 mins.
Cold weather and wind may effect your preheat time.
• If you are using volcanic rock or briquettes they can
increase the preheat time and maximum temperature.
• Too much insufficient air intake for the flame.
• Elevation is the principal cause, however cold weather can
affect the mixture. Burner adjustment may be required.
• Grill is in a windy location.
Troubleshooting
continued
26