Hyundai WFC 1047 D10 Instruction Manual page 33

FAULT
Unsatisfactory washing result.
As soon as the machine is loaded with
water, water discharges.
No water appears in the drum during
washing.
Laundries have detergent residues on them.
Grey spots appear on the laundries..
Wringing operation is not performed or runs
late.
(**) See the chapter regarding installation of your machine.
POSSIBLE CAUSE
Water being hard. (Dirty, hard, etc.)
Laundries distributed in your machine
nonhomogenously.
The end of water discharging hose is
too low for the machine.
No fault. Water in the non-visible part of the
drum.
Non-dissolving particles of some detergents
may adhere to your laundries as white
spots.
The reason for this spots may be oil, cream
or ointment.
No fault. Unbalanced load control system
has been activated.
ENG - 33
REMOVING METHODS
Adjust the amount of detergent based on
the instruction of detergent manufacturer.
Spread your laundries in the machine
properly and homogeneously.
Set the water discharging hose on appropriate
height. (**)
-
Perform an extra rinsing by setting your
machine to "Rinsing" programme, or clean
the spots using a brush after your laundries
dries.
Apply the maximum amount of detergent
instructed by the detergent manufacturer
in the next washing operation.
Unbalanced load control system will try to
spread your laundries homogeneously.
Wringing operation will start after spreading
your laundries. Put your laundries in the
machine homogeneously in the next washing
operation.
ENG