Table of Contents
Advertisement
This chapter provides you with environmental, unpacking and setup instructions.
Environment
Place your Ethernet Switch in a well-ventilated room.
•
0
Room temperature 0
C to 55
•
Relative humidity 10% to 90% (non-condensing)
•
Allow air circulation around fan vents to prevent overheating.
•
Do not place the unit where water might get on or into it.
•
Do not touch any electrical contacts or push any objects into the unit through the vents.
Remember, this equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with this user's guide, may cause harmful interference to radio communications.
Unpacking Your Ethernet Switch
Carefully open the box and remove the contents. You will find the following items:
•
One Ethernet Switch
•
One AC power cord
•
Four adhesive rubber desktop mounting feet
•
Two rack mounting brackets
•
Eight screws for rack mounting brackets
•
This User's guide
If any of the package contents are missing or damaged, please contact your Ethernet Switch dealer immediately.
Desktop Installation
The surface where you put your Ethernet Switch should be clean, smooth, level and sturdy.
Make sure there is enough clearance around the Ethernet Switch to allow attachment of cables, power cord and allow air
circulation.
Attaching Mounting Feet
1.
Make sure mounting surface on the bottom of the Ethernet Switch of grease and dust free.
2.
Remove adhesive backing from rubber mounting feet.
3.
Press adhesive to mounting nodes.
0
0
0
C (32
F to 131
F).
Figure 3-1. Attaching the rubber mounting feet.
Setting Up Your Ethernet Switch
Chapter 3
Advertisement
Table of Contents
