Yamaha NMX GPD125-A Owner's Manual page 54

Periodic maintenance and adjustment
4. Remove the coolant reservoir cov-
er.
1
1. Coolant reservoir cover
6
5. Remove the coolant reservoir cap,
add coolant to the maximum level
mark, and then install the reservoir
cap. WARNING! Remove only
the coolant reservoir cap. Never
attempt to remove the radiator
cap when the engine is hot.
NOTICE: If coolant is not
[EWA15162]
available, use distilled water or
soft tap water instead. Do not
use hard water or salt water
since it is harmful to the engine.
If water has been used instead
of coolant, replace it with cool-
ant as soon as possible, other-
wise the cooling system will not
be protected against frost and
corrosion. If water has been
added to the coolant, have a
Yamaha dealer check the anti-
freeze content of the coolant as
soon as possible, otherwise the
effectiveness of the coolant will
be reduced.
[ECA10473]
1
1. Coolant reservoir cap
Coolant reservoir capacity (up to
the maximum level mark):
0.25 L (0.26 US qt, 0.22 Imp.qt)
6. Install the coolant reservoir cover.
7. Place the right floorboard mat in
the original position and push it
downward to secure it.
6-14
To change the coolant
1. Place the vehicle on a level sur-
face and let the engine cool if nec-
essary.
2. Remove panels A and B. (See
page 6-7.)
3. Remove the radiator cover by re-
moving the bolts.
1
2
1. Radiator cover
2. Bolt
4. Place a container under the en-
gine to collect the used coolant.
5. Remove the radiator
WARNING! Never attempt to re-
move the radiator cap when the
engine is hot.
[EWA10382]
EAU67280
cap.