Yamaha NMX GPD125-A Owner's Manual page 24

Instrument and control functions
 "km/L": The average distance that
can be traveled on 1.0 L of fuel is
shown.
 "L/100 km": The average amount
of fuel necessary to travel 100 km
is shown.
3
 "MPG": The average distance that
can be traveled on 1.0 lmp. gal of
fuel under the current riding condi-
tions is shown.
To switch between the average fuel
consumption display settings, push
the "SELECT" button for one second.
To reset the average fuel consumption,
push the "RESET" button for at least
one second.
TIP
 After resetting the average fuel
consumption, "_ _._" will be
shown until the vehicle has trav-
eled 0.1 km (0.06 mi).
 When MPG is selected, no units
indicator will be displayed.
Oil change tripmeter mode
1 2
1. Oil change indicator "OIL"
2. Oil change tripmeter
The oil change tripmeter shows the
distance traveled since it was last reset
(i.e., since the last oil change).
The oil change indicator "OIL" will flash
at the initial 1000 km (600 mi), then at
6000 km (3500 mi) and every 6000 km
(3500 mi) thereafter to indicate that the
engine oil should be changed.
After changing the engine oil, reset the
oil change tripmeter and the oil change
indicator. To reset them both, select
the oil change tripmeter, and then push
the "RESET" button for one second.
Then, while "OIL" and the oil change
3-8
tripmeter are flashing, push the "RE-
SET" button for three seconds. The oil
change indicator will be reset.
If the engine oil is changed before the
oil change indicator comes on (i.e., be-
fore the periodic oil change interval has
been reached), the oil change tripmeter
must be reset for the next periodic oil
change to be indicated at the correct
time.
V-belt replacement tripmeter mode
1 2
1. V-belt replacement indicator "V-BELT"
2. V-belt replacement tripmeter
The V-belt replacement
shows the distance traveled since it
was last reset (i.e., since the last V-belt
replacement).
tripmeter