Table of Contents
Advertisement
Saving Channels to Memory
If you find a channel you like and want to listen to it again, save it to memory.
Press MEM/SOS; the active channel is stored in memory and MEM displays.
Press SCAN DUAL to scan the channels in memory.
-
You must have at least 2 channels in memory in order to use
Scan mode. Channel 70 and WX channels cannot be stored into
memory.
Press SCAN/DUAL again to remove the channel from memory.
Special Features
Using the Strobe SOS Light/Flashlight
You can use this radio in an emergency. If you turn on the strobe SOS high-
intensity LED light on your radio, your radio will blink "S O S" in international
Morse Code. This will make it easier for rescuers to find you faster.
-
Your radio operates normally when the SOS LED strobe is ac-
tivated.
With the SOS LED
in this state -
OFF
SOS
Continuous
Turning the key beep on and off
Key beep is the tone that sounds when you press a key or a button. You cannot
change the key beep volume.
To turn key beep on or off, press and hold Channel up or Channel down while
turning on the radio. You may need to turn off the radio first.
Setting Key Lock
You can lock and unlock the keypad by pressing and holding UIC/LOCK. If Key
Lock is on, only PTT, Boost, and power on/ off will operate. Key Lock remains
in memory when the radio is turned off.
Do This -
Press and hold Mem/
SOS for 2 seconds.
Press and hold Mem/SOS
for 2 seconds.
Press and hold Mem/SOS
for 2 seconds
23
For this -
SOS LED signals SOS in
Morse code
SOS LED remains on
continuously (Flashlight
mode)
SOS LED turns off
Advertisement
Table of Contents
