Mounting The Charger; Charging The Battery - PRESIDENT PM-2050 SWF Owner's Manual

1) Hold the lower part of the tray in one hand with the three battery contacts
facing down. Use your thumb to hold the notch on the lower part of the tray.
close the cover. (The cover fits snugly but you
should not have to force it closed.)
5) Install the alkaline battery tray in your radio just
as you do the Li-Ion Polymer battery (see page
17).
WARNING! The tray is designed to prevent the accidental charg-
ing of alkaline batteries. Never use alkaline batteries in the radio
without the alkaline battery tray. Do not attempt to modify the
battery tray design.

Mounting the Charger

You can mount the charger on any flat surface.
1) Use the two holes at the base of the charger as a
template to mark the drill holes.
2) Using a 1/8-inch (or 3 mm) drill bit, drill two holes
1/2 inch (13mm) deep.
3) Use the provided screws to attach the charger to
the surface.

Charging the Battery

Your radio includes a charger and a rechargeable battery
pack. Place your radio in the charger with the display facing
forward. Make sure that the CHARGE LED on the charger
turns orange.
2) With your other hand, grip the upper part of the
tray and lift the cover open.
3) Align the batteries' positive and negative terminals
with the drawing on the tray and snap each bat-
tery into place.
4) Insert the two hooks
on the lower part
of the tray into the
notches on the cover;
18