Important Notes On Charging The Battery; Attaching The Belt Clip - PRESIDENT PM-2050 SWF Owner's Manual

Cautions:
© Use only the battery and charger supplied with this radio. Us-
ing a different charger or battery can damage the radio and
create a risk of fire or shock.
© The charger is not waterproof. If the charger falls into the wa-
ter, unplug it before attempting to remove it from the water.
After you remove the charger from the water, please contact
your retailer.
© Wipe off dirt or shake water from your radio before placing in
the charger if your radio gets dirty or wet.

Important notes on charging the battery

© Charge the battery fully before using the radio. When the battery is com-
pletely charged, the CHARGE LED turns green.
© Don't use the charger when the ambient temperature is below 0° C (32° F)
or above 45° C (113° F).
© If the radio is powered down, the battery can charge in about seven hours.
(If the radio is powered on, the battery takes longer to charge.)

Attaching the Belt Clip

To attach the belt clip:
1) Rotate the belt clip so that the finger indentation
is towards the top of the radio.
2) Align the center of the clip with the anchor post.
3) Place the clip on the post and slide the clip up-
wards until it clicks into place.
To remove the belt clip:
1) Rotate the clip so that the finger indentation is
towards the bottom of the radio.
2) Slide the clip up until it comes free of the an-
chor post.
19