Advertisement
7
Insert downrod into yoke on top of the Fan
Body. Align the hole in the Downrod with the
hole in the Yoke. Insert the Pin through the
Yoke and Downrod until the point appears on
the other side. Install the keeper to pin.
10
Hang assembled fan from the mounting bracket
installed to ceiling in previous step. Make sure the
fan is hanging straight. Rotate fan until the tab on
the Mounting bracket engages the slot on the
Downrod Ball. This must be done to prevent the fan
body from rotating when the blades are in motion.
13
Slide remote receiver into mounting
bracket.
16
Align the blade with castings on
motor to attach blades to motor.
8
Tighten the 2 set screws on the Yoke
once the downrod is in place.
11
white
black
Make wiring connections as indicated above.
White from fan to white from remote marked
N. Blue from fan to blue from remote marked
light. Black from fan to Black from remote
marked L. White from house to white from
remote marked AC N . Black from house to
Black from remote marked AC L. Connect all
green ground wires to Ground wire from
House.
14
Make wire connections to power source using wire nuts
provided. Make sure that no filiments are outside of
the wirenut. After making the wire connections, the
wires should be spread apart with the grounded con-
ductor and the equipment-grounding conductor on one
side of the outlet box and ungrounded conductor on
the other side of the outlet box.
17
Loosen 2 screws and remove 1 screw
from motor plate and save screw.
9
Safety cable installation
Safety Cable
Lag Screw
safety
cable
washer
lock
3" lag
washer
screw
For Canadian installation and for USA fan and
light kit combinations over 35 lbs, in both flush
and downrod mode the safety cable must be
installed into the house structure beams using
the 3" lag screws,washers, and lock washers.
provided. Make sure that when the safety cable
is fully extended the leadwires are longer than
the cable and no stress is placed on the lead-
wires.
12
Remote Transmitter Dip swtiches
Remote Receiver Dip switches
Set dip switches on the Remote T ransmitter and Remote
Receiver to the same settings. This must be done so the
units will communcate properly . If you have other fans you
can set to control from one transmitter by setting both
receivers the same as the transmitter . If you have more
than one fan with remote. You can set the dip switches to
different positiosns to have seperate control.
15
Next lift the canopy, twist into place and
tighten 2 screws securely. The canopy
should adjust for any irregularity in the
ceiling or Outlet box.
18
Install light plate by twisting plate
with key hole slots into place.
Replace screw removed and tighten
the 3 screws securely.
Advertisement
