Replacing The Palm-Rest Assembly - Dell Inspiron 1090 Service Manual

1 left hall-sensor cable connector
3 palm-rest assembly
5 touch-pad cable connector
CAUTION:
9. Using a plastic scribe, carefully pry out the palm-rest assembly along the rear edge and then ease the palm-rest assembly from the computer base.
1 palm-rest assembly
10. Lift the palm-rest assembly off the computer base.
Replacing the Palm-Rest Assembly
1. Follow the instructions in
2. Align the palm-rest assembly on the computer base and gently snap the palm-rest assembly into place.
3. Slide the touch-pad cable, left hall-sensor cable, and right hall-sensor cable into the connectors on the system board and press down on the connector
latches to secure them.
4. Replace the four screws that secure the palm-rest assembly to the computer base.
5. Replace the keyboard (see
6. Replace the six screws to the computer base.
7. Replace the label door (see
More user manuals on
2 screws (4)
4 right hall-sensor cable connector
Carefully separate the palm-rest assembly from the computer base to avoid damage to the palm-rest assembly.
2 plastic scribe
Before You Begin.
Replacing the Keyboard).
Replacing the Label Door).
ManualsBase.com