Removing The Palm-Rest Assembly - Dell Inspiron 1090 Service Manual

Back to Contents Page
Palm-Rest Assembly
Dell™ Inspiron™ 1090 Service Manual
Removing the Palm-Rest Assembly
Replacing the Palm-Rest Assembly
WARNING:
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
is not covered by your warranty.
CAUTION:
surface (such as a connector on your computer).
CAUTION:
computer.
Removing the Palm-Rest Assembly
1. Follow the instructions in
2. Remove the label door (see
3. Remove the keyboard (see
4. Close the display and turn the computer over.
5. Remove the six screws from the computer base.
6. Turn the computer over and open the display as far as possible.
7. Lift the connector latch and pull the pull-tab to disconnect the touch-pad cable, left hall-sensor cable, and right hall-sensor cable.
8. Remove the four screws that secure the palm-rest assembly to the computer base.
More user manuals on
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
To help prevent damage to the system board, remove the main battery (see
Before You Begin.
Removing the Label Door).
Removing the Keyboard).
ManualsBase.com
Removing the Battery) before working inside the