Gigaset S455 User Manual page 11

First Steps
¤
Insert your hand into the headset
socket cavity and pull the battery cover
upwards.
Placing the handset in the base station
and registering
¤
Place the handset in the base with its
display facing outwards.
The handset registers automatically. Reg-
istration takes around 1 minute. During
this time
Regstr.Procedure
display and the name of the base station
flashes, e.g. Base 1. The handset will be
assigned the lowest unassigned internal
intercom number (1–6).
This will appear in the display when regis-
tration is complete, for example
means that the number 1 has been
assigned. If the internal numbers 1–6 are
already assigned to other units, the
number 6 is overwritten.
Note:
– Automatic registration is only possible if
no-one is making calls using the base sta-
tion.
– Each key press interrupts the automatic
registration.
– If automatic registration does not work the
handset will need to be registered manually
(page 25).
– You can change the name of the handset
(page 28).
8
appears in the
INT 1. This
To charge the batteries, leave the handset
in the base station.
Note:
– If the handset has switched itself off
because the batteries have no charge and is
then placed in the base station, it will
switch itself on automatically.
– Only place the handset in the base or
charging cradle that is intended for it.
For questions and problems see page 38.
Headset socket
Which headsets are compatible?
The following headsets have been tested
with the S45:
u
Plantronics M40
u
Plantronics MX100
u
Plantronics MX150
Initial charging and discharging of
batteries
If the handset is activated, the flashing
battery icon e in the top right of the dis-
play indicates that the batteries are being
charged.
During handset operation, the battery
icon indicates the charge status of the bat-
teries (page 1). The correct charge level
can only be displayed if the batteries are
first fully charged and discharged.
¤
To do this, leave the handset in the
base or charging cradle continuously
for ten hours. Your handset need not
be switched on for it to charge.
¤
Afterwards, remove the handset from
the base station and do not put it back
again until the batteries are fully dis-
charged.
Note:
After the first battery charge and dis-
charge you may replace your handset
in its base after every call.